What mode am I in and how do I change modes?

How do I know what mode my sensor is currently standardized in and how can I change modes?

The easiest way to tell what mode the instrument is using in the EasyMatch QC software is to locate the status bar in EasyMatch QC. The status bar is located at the very bottom of the software indicated in red in the picture below. This provides information about the sensor in the current mode, and when the standardization for that mode expires.

Continue reading

What is a Y Brightness? Beta Reflectance Factor? Reflection Coefficient?

FAQ: What is a Y Brightness/Luminance?

FAQ: What is a Beta (ß) Reflectance or Luminance Factor for Brightness?

FAQ: What is a Reflection Coefficient (0-1)?

Continue reading